Your water heater is one pretty used and more expensive appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating as well as costs.
Regular flushing of your water heater is among the single most important step you get to prolong its service life and even save energy. Over a period of time, sediments mount up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the typical water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s markets. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, which will help should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located in the water inlet line going into your water heater. You can then connect a hose to the drain valve located at the base of the heater. Open the drain and allow it to move until all of the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the actual flows out gradually. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so may less corrosive to your plumbing system, particularly in areas which have hard hot water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and merchandise to work for you.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX